Description

CONTACT CUSTOMER SERVICE FOR PRICE AND LEAD TIME. 678-383-6420

!!! INSURE THE APPLICATION TESTS FOR THE CORRECT VOLTAGE, CYCLE, AND PHASE BEFORE PURCHASING !!!

Three phase applications available as well

EWD36 Wall Fan Extruded Aluminum Propeller Direct Drive

36EWD

REPLACEMENT MOTOR SINGLE PHASE 115 VOLT: Please email or call for pricing

REPLACEMENT MOTOR THREE PHASE: Please email or call for pricing

REPLACEMENT BEARINGS: Please email of call for pricing

REPLACEMENT SHAFT: Please call or email for pricing

REPLACEMENT BLADE: Please email or call for pricing

REPLACEMENT TOPCAP/LID: Please email or call for pricing

CONTACT CUSTOMER SERVICE FOR PRICE AND LEAD TIME. 678-383-6420

EWD

Wall Fan
Extruded Aluminum Propeller
Direct Drive

Description: Fan shall be a wall mounted, direct drive, extruded aluminum propeller exhaust fan.

Certifications: Fan shall be manufactured at an ISO 9001 certified facility. Fan shall be listed by Underwriters Laboratories (UL 705) and UL listed for Canada (cUL 705).

Construction: Fan shall be of bolted and welded construction utilizing corrosion resistant fasteners. The motor shall be mounted on a 14 gauge steel power assembly. The power assembly shall be bolted to a minimum 14 gauge steel wall panel with continuously welded corners and an integral venturi. Unit shall bear an engraved aluminum nameplate. Nameplate shall indicate design CFM and static pressure. Unit shall be shipped in ISTA Certified Transit Tested Packaging.

Coating: All steel fan components shall be LorenizedTM with an electrostatically applied, baked polyester powder coating. Each component shall be subject to a five stage environmentally friendly wash system, followed by a 1.5 to 2.5 mil thick baked powder finish. Paint must exceed 1,000 hour salt spray under ASTM B117 test method.

Propeller: Propeller shall be extruded aluminum airfoil design with cast aluminum hub. The blade pitch shall be factory set and locked using set screws and roll pin. The hub shall be keyed and locked to the shaft utilizing two set screws or a taper lock bushing. Propeller shall be balanced in accordance with AMCA Standard 204-05, Balance Quality and Vibration Levels for Fans.

Motor: Motor shall be heavy duty type with permanently lubricated sealed ball bearings, and furnished at the specified voltage, phase and enclosure.